If you wish to support the development you can send me a coffee here https://buymeacoffee.com/peterdd</p><p></p><p>* To use this app you have to add the data field to an existing activity profile such as "run".</p><p>* To configure the data field use the connect iq mobile app or garmin express on a computer. </p><p>* Choose the correct operating mode, when you have paired your sensor in the firmware device settings then use "paired" in the settings... </p>
2.5 new devices support</p><p>2.3 added ability to enter tempe offset </p><p>2.0 add support for watches and handhelds (with a choice between a paired tempe (default) and unpaired tempe)</p><p>1.0 added possibility to show a label, fixed tempe chart on Edge 130, implemented donation key</p><p>0.2 clear history graph when the timer is reset</p><p>0.1 initial release
此应用程序需要对下列各项的访问权:
Pavel Vraj
2022年8月29日
It works perfectly on Edge Explore 2, no interference with my other ant+ sensors and devices.
Jacek Betler
2022年8月29日
The temperature versus time graph should be corrected. During the 8-hour hike, it is unreadable and shows little of it.
Hostrup 🇩🇰
2022年8月16日
Sadly it didn't quite work out as expected on my Tactix Delta Solar (Fenix 6X). I enabled the "store into .fit file" or some wording like that, and it would not sync my activity! I had to manually transfer it from my device, and upload it to Connect. However, I did a walk-activity (also with this datafield enabled) and it worked fine? I should point out though, that I had enabled the graph when I did the walk-activity, whereas the graph was disabled when I did the run-activity. Would be a useful datafield if I could get it to work. Thanks for putting an effort into this software, free of charge! Much appreciated!
John Krueger
2022年7月30日
Been using this for a while on my 1030 plus, and it works great. It's nice to have a relatively accurate temperature record, since the internal thermometer can be so wildly inaccurate sometimes ((I've seen 40 degrees to high on sunny days.) The only issue I've encountered was when I had an action camera also connected to the Tempe, it seemed to prevent the 1030 plus from connecting, but when only the 1030 plus is connected, the data field works perfectly.