JMG-DTF Cycling VO2 Max

Resposta do desenvolvedor
27 de Agosto de 2022, Surfy66

Hello D. Karat and thanks for your comment. Since its release, this data field has never consumed excessive battery power. If this is happening on your watch, it's probably due to the firmware, as sometimes happens after a firmware update. Did you try to soft reset your watch after the firmware update, this often solves this kind of issue.

Resposta do desenvolvedor
19 de Julho de 2022, Surfy66

Hello Leigh and thanks for your comment. This datafield is working fine, unless the data (HR or power) sent to it are not correct. The datafield does not run by itself, it needs HR or power values in order to work properly but, if these data are not correct (bad HR or power values), the calculations made by the data fields will also be false, that may explain your bad result. Check the data calculated and sent by your sensors, and this should fix your issue. If all is correct, I cannot explain the situation without more explanations and details, except if you reach me by email.

Resposta do desenvolvedor
11 de Abril de 2022, Surfy66

Hello Zahir and thanks for your comment. Can you please send me an email with the Contact Developer link (don't forget to write down your email address in your email) so that, I will be able to help you. Because there, I have no informations that could help me to search for a solution (device model, etc)

Resposta do desenvolvedor
8 de Fevereiro de 2022, Surfy66

Hello Piotr and thanks for your comment. This field is only used to enter the last known VO2 max value (calculated by the datafield), just in case you would have to reinstall the datafield (or install it on a new watch). So, with it, you start again with the last known value, and not a null value. I normal condition, this field should be left as is.

Resposta do desenvolvedor
21 de Novembro de 2021, Surfy66

Hello Sofie and thanks for your comment. The algorithms use either HR or power to calculate your VO2, even if your real speed is null. So, the result should be the same as if you were outdoor. I never tested it indoor with this kind of equipment but, in theory, it should work the same way as for outdoor.

Resposta do desenvolvedor
12 de Outubro de 2021, Surfy66

Bonjour Isma. Tout d'abord, il vous faut télécharger le datafield du store Garmin pour le copier sur votre montre, soit via Garmin Connect soit en utilisant Garmin Express. Ensuite, de nombreux autos existent sur cette procédure, par exemple cette vidéo, qui vous montre le pas à pas de l'installation: https://www.youtube.com/watch?v=J5IXgyBMuX8

Resposta do desenvolvedor
1 de Setembro de 2021, Surfy66

Hello Jakub and thanks for your comment. Firstly, both algorithms (Garmin and mine) are probably different. Secondly, Garmin one start to determine the VO2 max after several activities, whereas mine starts its VO2 max calculation from the first activity. This may explain the main difference. Finally, the VO2 max is calculated for each activity, that can have different intensity so, you need to consider the smoothed VO2 max, that corresponds to the VO2 max calculated all over your activities, and may tend in the near future to the Garmin VO2 max value. Another explanations can be wrong personal infos set in the settings of the datafield.

Resposta do desenvolvedor
27 de Agosto de 2021, Surfy66

Hello Syverin and thanks for your comment. On the Venu2 model, you can access the settings directly within the watch without using Garmin Connect. Just open the sport profile where the datafield is associated, select it in the menu then, enter the settings by tapping on screen to enter all the settings of the DF. With this feature, you can now configure and set up your DF without using your phone + Connect