With increasing elevation and decreasing pressure, amount of effective oxygen in the air descreasing too. On sea level there's about 20,9% of oxygen in the air. This widget will show you a percentage of oxygen in actual elevation, elevation and if you will have Tempe sensor connected, it will show the temperature too (use at your own risk).</p><p></p><p>==========================================================</p>
v4.1.0 - Support for Marq Commander and Adventurer, vivoactive 4/4s, Legacy Cpt.Marvel & First Avenger
이 앱은 다음에 대한 액세스 권한이 필요합니다.
Andrija
2022년 5월 13일
Nayan Goswami
2021년 5월 26일
Albino Binoe Azurin
2020년 10월 24일
Henry
2020년 8월 4일
Do I have to recalibrate every time I open it? I’m on a vivoactive 3.
개발자 회신
2020년 8월 5일, mr3ska
Widget works with elevation measured by the device sensor. It hasn't any own data source. It takes the data from the device system and these values are used for oxygen percentage calculation. There is no way to change the values measured by sensor through the Connect IQ widget.
HeMax 𓅂 ☮︎︎ ⚔︎
2020년 6월 21일
Thanks for the reply to my pre Que. The bottom line shows "connect tempe" Why isn't it showing temperature there? Fenix 3hr Thank you
Micmap
2020년 6월 17일
Hi Sir, thanks for the wonderful app. However the figure now is minus meter but actual is around 17m. Would you please help how to reset or could adjust by manually, thank a for your kindly help.
Jackson
2020년 6월 5일
units does not match settings. only show feet and F degrees, no meter and C degrees.
Wilfried
2020년 5월 16일
I have it on my Fenix 3, and I liked it so much! Now I have a Garmin Venu, can you please port it to this watch to - thanks a lot!
Reto Musterle
2020년 5월 13일
Hello, can you show besides calculated oxygen level as well the measured one from garmin 945?
George
2020년 3월 26일
Μετράει τα επίπεδα οξυγόνου στον αέρα; Ή είναι ένα παλμικό οξύμετρο για τον άνθρωπο;