With increasing elevation and decreasing pressure, amount of effective oxygen in the air descreasing too. On sea level there's about 20,9% of oxygen in the air. This widget will show you a percentage of oxygen in actual elevation, elevation and if you will have Tempe sensor connected, it will show the temperature too (use at your own risk).</p><p></p><p>==========================================================</p>
v4.1.0 - Support for Marq Commander and Adventurer, vivoactive 4/4s, Legacy Cpt.Marvel & First Avenger
このアプリは次の情報にアクセスする必要があります:
Albino Binoe Azurin
2020/10/24
Henry
2020/08/04
Do I have to recalibrate every time I open it? I’m on a vivoactive 3.
開発者の返信
2020/08/05, mr3ska
Widget works with elevation measured by the device sensor. It hasn't any own data source. It takes the data from the device system and these values are used for oxygen percentage calculation. There is no way to change the values measured by sensor through the Connect IQ widget.
HeMax 𓅂 ☀︎︎ ⚔︎
2020/06/21
Thanks for the reply to my pre Que. The bottom line shows "connect tempe" Why isn't it showing temperature there? Fenix 3hr Thank you
Micmap
2020/06/17
Hi Sir, thanks for the wonderful app. However the figure now is minus meter but actual is around 17m. Would you please help how to reset or could adjust by manually, thank a for your kindly help.
Jackson
2020/06/05
units does not match settings. only show feet and F degrees, no meter and C degrees.
Wilfried
2020/05/16
I have it on my Fenix 3, and I liked it so much! Now I have a Garmin Venu, can you please port it to this watch to - thanks a lot!
Reto Musterle
2020/05/13
Hello, can you show besides calculated oxygen level as well the measured one from garmin 945?
George
2020/03/26
Μετράει τα επίπεδα οξυγόνου στον αέρα; Ή είναι ένα παλμικό οξύμετρο για τον άνθρωπο;
まだ利用可能な統計はありません。